Nederlands | English | Deutsch | Türkçe

Project Sports

Questions and answers about sports

Why is my golf cart sputtering?

4 min read

Asked by: Cynthia Segura

Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.

Why is my electric golf cart sputtering?

If your cart seems to run fine for a few feet, and then it stutters, it is most likely the batteries. If it is not the battery, then check if it is the speed controller or the resistor. If it is the controller, then you will need a replacement. Otherwise, upgrading the resistor can also solve the problem.

What causes golf cart hesitation?

If your cart does not start smoothly, hesitates before starting, or does not gain speed properly, these are all signs of a bad or damaged accelerator.

How do you stop a golf cart backfiring?

One of the simplest ways to reduce backfiring while operating a golf cart is to adjust the throttle plate so the controller does not apply fuel when the motor is idle. This makes it more difficult for residual pressure to build inside of the manifold and cause backfiring.

Why does my electric golf cart go slow uphill?

The Reason Your Electric Golf Cart Goes Slow Uphill? Your electric golf cart can struggle on inclines for a variety of reasons. Weak batteries, incorrect tires, and wear and tear to the motor and wiring are all potential causes of your cart’s slow speed.

How do I know if my electric golf cart motor is bad?

You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won’t start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.

What makes a golf cart surge?

A golf cart can be surging due to insufficient fuel levels, damaged motor brushes or a vacuum leak. The brushes in the motor are damaged or worn out. The MCOR is malfunctioning or a mismatch between the motor and controller results in torque bumps.

Why is my ezgo golf cart going so slow?

A EZGO RXV and TXT golf cart can run slow because of a faulty speed sensor, low battery charge and insufficient levels of water in the battery. A problem with the speed sensor. A faulty speed magnet. One or more batteries could are weak and don’t have sufficient charge or the water level could be low.

Why is my Club Car losing power?

The Club Car golf sometimes faces the trouble of losing power while trying to get started. The main reason why a Club Car golf cart has no power is due to a faulty regulator or bad battery. One of the most common reasons could be a bad regulator and the connections to the regulator needs to be checked.

How can I make my golf cart climb hills better?

An older cart can be upgraded to perform better up hills. Adding larger 20″- 23″ all terrain tires will help. 1) Tighten your terminal connections. 2) Clean any corrosion on battery terminals and cables.

Why does my electric Club Car go slow?

The main reasons for a Club Car Precedent running slow is because of a weak battery, or faults with the MCOR, solenoid and throttle cable. Some of the other reasons the cart may slow down are: Solenoid contacts can get jammed as they wear out; experts call this ‘welded solenoid’.

How do you speed up an electric golf cart?

6 Ways You Can Make a Golf Cart Faster

  1. Add More Torque to Your Golf Cart.
  2. Upgrade Your Golf Cart’s Motor.
  3. Improve the High-Speed Controller of the Cart.
  4. Add Better Golf Cart Tires.
  5. Use a Higher Powered Golf Cart Battery.
  6. Watch the Weight in Your Golf Cart.

How do I increase the torque on my electric golf cart?

Change the Speed ControllerThe Speed Controller regulates the electric output of the motor; a higher voltage equals more RPM, and the faster your cart will travel. When you change the speed controller, you can reduce the voltage and increase the amperage of the motor, resulting in increased torque.