What is Skatelite pro?

Asked by: Jeremy Robinson

What is Skatelite made of?

Skatelite products are made from a super-durable paper-composite material that is designed to stand up to the daily punishment inflicted by skateboards and BMX bikes.

How long does Skatelite last outside?

Skatelite that has been in place at some parks for over three years and is still in good shape. It has weathered severe winters in a several locations without any ill- effects. If properly installed with sufficient substrate, five to ten years seems reasonable.

What is Skate Lite?

Skatelite is an incredibly durable solid paper composite material used as a riding surface for extreme sports. Made by Richlite, who has been manufacturing paper composite panels for more than 70 years, Skatelite is the same material that has been used by the aerospace, marine and A&D industries.

How do you wash Skatelite?

Using the pressure washer super simple you're gonna connect the hose plug. It in once you've turned it on select the high pressure setting. And then you'll want to spray the transition.

Is Masonite good for skate ramps?

Masonite, in essence, is a glorified cardboard. Its smooth and works great- but if it is going outside, plan on replacing it in a few weeks! Masonite on any skate ramp does not hold up well when it gets wet. It will bubble and be destroyed faster than you can spell s-k-a-t-e-b-o-a-r-d!

What is the best surface to skateboard on?

You can skate over pebbles with the right wheels. Soft wheels (e.g. 77A – 80A) are soft enough to roll over small pebbles by squishing around them when rolling fast. Besides softness for cushioning, the bigger the wheels the better for rolling over pebbles, gravel, and small rocks.

How do you put on Skatelite?

Skatelite is a super hard surface. So you always want to use a finish blade carbide tip saw blade. It will give it a nice clean cut and then the edge might be a little sharp. So you can use the 8 inch

Should I paint my skate ramp?

If you do not use skatelite (either massonite or no top surface), it is a good idea to use water resistant paint to protect it from sun and rain. Two types of paints that work well for this is Spar Urethane and Polyurethane Paint.

How thick should plywood be for skate ramp?

For covering the ramp face, we’re going to use two layers of 3/8″ thick plywood and then a final layer of 1/8″ on top. Start by pushing a sheet of 3/8″ tight against the coping and screwing it down to the 2x4s below. Repeat it all the way across the ramp, making cuts as needed until the entire thing is covered.

What is ramp armor made of?

Unlike the other guys out there, Ramp Armor is more affordably priced and lasts just as long while riding just as good, if not better. Made with high-quality materials and 100% cotton.

How do you clean a skatepark?

And you'll notice there's a good amount of rust on there rubbing alcohol is great for removing rust which is why you can use it to clean skateboard. Bearings. So take a rag.

Can you skate on a wet skatepark?

Skating in the rain or even just on damp ground can affect your bearings and reduce their efficiency. After a wet skate it’s important to clean your bearings to ensure no permanent damage is done.

How do you dry a skatepark fast?

What you're actually doing is using the towel to drag the water around and spread it out the same way that you would use a squeegee.