What Gates Carbon Drive parts should I upgrade?

Asked by: Jeanne Ganguli

How long does a Gates carbon belt drive last?

30,000km

Your average belt drive will last upwards of 30,000km. Gates promises ”more than twice the life of a chain.” Because the carbon belt doesn’t stretch like a chain does, it lasts a lot longer before needing to be replaced.

When should a gate belt be replaced?

When to change accessory belts. Statistics show that failures increase dramatically after the fourth year of service, so Gates recommends that auxiliary belts be replaced at least every four years or 100,000 km (62,000 miles).

Are carbon belt drives good?

A belt drive is manufactured with carbon fibres through the core. This allows a belt drive to be much lighter than a bike chain but also gives it inherent strength. Light and tough. This toughness means unless you abuse the belt drive it can last a long time with durability to be cost effective.

Is a Gates belt drive worth it?

Belt-drive bikes are worthwhile if you don’t mind paying extra to minimize maintenance. They may last 20,000 miles or more (about 10x longer than a chain), and don’t use any grease. However, they require an internally-geared hub and are less mechanically efficient than a chain drive.

How do you maintain a gate belt drive?

Belt drivetrains are almost maintenance-free. Cleaning is often as simple as rinsing the belt/cogs using a water bottle and an old toothbrush. No degreaser. No chain cleaner.

How tight should Gates belt drive be?

Much like a normal chain, there isn’t one correct answer. So long as the belt stays in place and does not slip, there is a wide range of acceptable tension. With too little tension, the belt will skip; too much tension creates noise and is harder on bearings.

How long will a gates timing belt last?

Avoid Costly Engine Damage; Change Your Timing Belt At The Recommended Interval Or Every 72 Months, Which Ever Comes First.

How long will a softwood gates last?

between 7-8 years

The Lifespan of Softwood Gates



Softwood gates are more cost-effective than their hardwood counterparts, with their typical lifespan being between 7-8 years. Applying treatment during the first 12 months after being installed, will keep your softwood gates looking spectacular.

Should my gates open in or out?

The convention is that gates open into the direction visitors will be travelling, just as doors open into the house or a specific room. The thought is that it is more welcoming to have the gate swing away from rather than toward the visitor. So gates tend to open into the area that the fences enclose.

Which is better V belts or cog belts?

Cogged belts can be used with the same pulleys as equivalently rated V- belts. They run cooler, last longer, and have an efficiency that is about 2% higher than that of standard V-belts.

Are Kevlar drive belts better?

Overview: Kevlar vs standard v belts



Kevlar belts will hold up better in high shock load drives that have frequent starting/stopping and multiple directional changes. Standard belts are best suited for smooth operating drives with consistent speeds and low loads.

What are 3 types of drive belts?

There are three types of drive belts:

• Serpentine Belt. A serpentine belt is located under the hood of a car, and it “snakes” its way between various pulleys and accessories. …
• V-Belt. A V-belt runs off a crank and pulley and typically travels between one or two engine accessories. …
• Timing Belt.

How long do gate Motors last?

Under normal circumstances and with good care, it should last two to three years. Here are some tips as to how to take care of your gate motor so that you get maximum life from it.

How long do automatic gate motors last?

Typical lifespan of automatic driveway gate openers is about 10years– with 1-2 small repairs needed in the interem.

Do gates belts squeal?

The belt squeals because there is improper tension in the belt drive system. This is usually caused by a worn automatic tensioner, but other causes can include a contaminated belt (oil, belt dressing, etc.) or a belt that is too long or worn out.

How long will a Gates timing belt last?

Avoid Costly Engine Damage; Change Your Timing Belt At The Recommended Interval Or Every 72 Months, Which Ever Comes First.

How long does a Gates serpentine belt last?

Serpentine belts are built to last—much longer than before because of advancements in rubber technology. Under ideal conditions, a belt should stick with you for an average of 60,000 to 100,000 miles.

How long do belt drives last?

60,000 to 100,000 miles

Mileage Indicators



Today, most serpentine belts are expected to last anywhere from 60,000 to 100,000 miles. Some belts can last significantly longer than this, while others give out before 60,000 miles. Make sure to check your owner’s manual to find out the recommended belt replacement time frame.

Are Gates belts lifetime warranty?

Gates offers a one-year warranty for G-Force^™ snowmobile belts and ATV/UTV belts under normal use. Find the warranty claim form here.

Do Gates belts squeal?

The belt squeals because there is improper tension in the belt drive system. This is usually caused by a worn automatic tensioner, but other causes can include a contaminated belt (oil, belt dressing, etc.) or a belt that is too long or worn out.

Do Gates belts squeak?

After a break in period, the Gates Carbon Drive belts can develop a squeak. This usually happens most often in dry and dusty climates like those of the Southwest.