How does the Ferguson system work?
3 min read
Asked by: Stephanie King
The ‘Ferguson System’ – elements of which were patented throughout the 1920s – was in the end a triangular set of three attachment points by which the trailed implement would lock fully into the back of the tractor; and in such a way that concentrated pressure, and thus tractive power, low down and towards the front of …
What is Ferguson System tractor?
The Ferguson TE20 is an agricultural tractor designed by Harry Ferguson. By far his most successful design, it was manufactured from 1946 until 1956, and was commonly known as the Little Grey Fergie. It marked a major advance in tractor design, distinguished by lightweight, small size, manoeuvrability and versatility.
How do you use a Ferguson tractor?
The short stick is your low in hi Gil. Low mini making the track to go slower. High and meaning making it try to go faster. The long stick handle. It allows you to put the tractor in reverse.
How does draft control work on a tractor?
Right here in your top link has two little plungers underneath it and they are sensing at all times with draft control where that plow is.
How do I adjust the governor on my Ferguson tractor?
The governor linkage rod here. And this is where there's a return spring. And you have a rod coming down to your governor here. So we're trying to keep everything in the frame.
How do you start a Ferguson tractor?
That's off you want to stop the track to push it in that's ready to go to start the mower on this one on the gear lever at the top right hand side there is an S for. Start.
How do you engage a Massey Ferguson 4 wheel drive tractor?
I just push it and it comes right right loose. There's your clutch right there and you're going to engage your clutch to engage your pto. And your power takeoff is right below the clutch.
How do you adjust a carburetor on a tractor?
Set. Most your idols were set at 425 rpms. Okay you want to set this with a tachometer. It's the only way you're gonna know the RPMs. Now we come down to the idle air mixture.
How do you adjust air and fuel mixture?
What you do is take a screwdriver. And turn the screw. In until it slows down the engine. And then you pull it out a half a turn until it speeds back up do it on both sides of the carburetor.
How do you tell if a carburetor is rich or lean?
If the mixture is too lean, it will leave no color, while a rich mixture will cause the fuel ring to become more prominent. Over-rich mixtures will give the plug a sooty appearance.
