How do you install a blow up pool?
7 min read
Asked by: Teresa Tornatta
What do you put under a blow up pool?
What To Put Under An Inflatable Pool. Smaller inflatable pools will do fine with just a tarp underneath them, or nothing at all if on flat grass free of debris. But larger inflatable pools, or pools set up on concrete should have a ground cloth or a pool floor liner pad to protect the pool from damage.
How do you set up an inflatable pool?
How to set up an inflatable pool.
- Level the ground first.
- Spread out a tarp.
- Hook up the pump hoses to the pool and pump.
- Use a water hose to fill up the pool.
- Fill pool until full.
- Once pool is full, add chemicals, and place pool cover over top.
How do you install an above ground pool blow up?
Eight Easy Steps to Setting Up Your Inflatable Pool
- Select a Location.
- Start by Laying Down a Tarp.
- Set the Pool Down.
- Install Support Beams.
- Next, Inflate the Top Ring.
- Connecting the Inflatable Pool Pump.
- Fill with Water.
- Accessories.
How do you prepare the ground for a pop up pool?
Proper preparation of your level foundation will yield many summers of fun in the sun.
- Choose the best area of your yard to set up your pool. …
- Mark the perimeter of the pool area. …
- Remove all sod and other vegetation from the area. …
- Determine the lowest point of the pool area. …
- Create a wood level.
Can you put inflatable pool on grass?
Chlorine chemicals will kill most strains of grass, but when diluted in pool water, it’s safe to splash on the grass. Most inflatable pool water will be safe to splash on the yard, and even many plants or flowers will be fine with it.
Should I put a tarp under my pool?
At the bare minimum, yes you should put a tarp underneath your Intex pool. Inflatable pools, Bestway and Summer Ways pools will also benefit from a tarp. What is this? Although a tarp will help protect your pool there are far better choices such as foam tiles or proper commercial under pool pads.
How do you protect an inflatable pool from the ground?
An inflatable pool’s vinyl must be protected from rocks, sticks and hard grasses beneath it, but there are other ways that the material may become damaged. Make sure that toys with sharp edges are not permitted in the pool because they may puncture the vinyl.
How do you set up an Intex inflatable pool?
Unroll the pool liner on top of the ground cloth. Making sure it is right side up. Do not drag the pool across the ground since that may result in leaks locate the filter connecting holes.
How do you fill an inflatable pool without a hose?
The easiest way to blow up an inflatable pool is by using an electric air pump. Other simple options include using a shop-vac, air compressor, a hair dryer with a water bottle, manual hand or foot pumps, a large bag, or manually blowing up the inflatable pool yourself.
What do you put under a pool?
Things You Can Put Under Your Pool
- Concrete Pads.
- Commercial Pads.
- Sand.
- Solid Foam.
- Carpet Padding.
- Flooring Underlayment.
Can you put above ground pool on grass?
Installing an above-ground pool on a natural grass lawn is not a good idea, particularly if you plan on taking down the pool for part of the year. There are several reasons why natural grass and above-ground pools do not mix well, but one of the most important is that the pool is going to kill the grass.
How many bags of sand do I need for an above ground pool?
So how much sand will you need? You will need at least 2 inches (5.08 cm) of sand for your above-ground pool lining. For an average 15 × 30 foot (4.5 x 9.1 m) rectangular pool, you will need around 2-3 cubic yards (1.53 – 2.29 cu m) of sand or approximately 4 tons (3600 kilos).
How much area will a 50 lb bag of sand cover?
50 lb bag of sand cover how much area?” Generally, a typical 50 lb bag of sand yields 0.5 cubic feet, which will cover approximately 3 square feet area for standard 2 inch depth, 6 square feet at 1 inch deep, 2 square feet at 3 inches deep, or 1.5 square feet at 4 inches deep.
How do you level a pool?
- STEP 1: Determine your location and remove any large rocks or debris. …
- STEP 2: Place 2x4s on the site and place a level on top. …
- STEP 3: Add or take away soil until the ground is level. …
- STEP 4: Repeat the process until the entire area is flat. …
- STEP 5: Rake any remaining rocks or debris and tamp the ground.
- Outline your plot with stakes and string to create a boundary for the cultivation. Hammer stakes into the ground at each corner of the area to be cultivated. …
- Dig up the soil. Start at one corner of your plot and insert the shovel about halfway into the soil. …
- Hoe the area. …
- Rake the area to further level the ground.
- Drain some water. You are going to be lifting the lower side of the pool, so you need to get rid of some of the weight. …
- Remove blocks. When you installed the pool, you put leveling blocks under the slab. …
- Raise the wall. …
- Replace blocks. …
- Repeat. …
- Fill the hole. …
- Refill the pool.
What type of sand goes under a pool?
mason sand
The sand that lies underneath your pool is called “mason sand”, while the sand for your filter is simply called “filter sand” or “silica sand”.
How many bags of sand do I need for a 18 foot pool?
How Much Sand Will I Need For Pool Installation?
| Amount for Sand Base with SAND COVE | ||
|---|---|---|
| Pool Size | Yards of Sand | Tons of Sand |
| 12′ Round | 1.00 | 1.40 |
| 15′ Round | 1.50 | 2.00 |
| 18′ Round | 2.00 | 3.00 |
What kind of foam goes under a pool?
And then laying the table along seams and just ensuring that the seams are tight by squeezing it together and just putting you know those squares.
How many inches of sand do you need for a pool?
The standard depth of sand that should be used under an aboveground pool’s floor is 2 inches.
Should I put sand under my Intex pool?
The folks at Intex are fairly clear that you should NOT put sand under your pool. The sand can easily wash away, causing voids under your pool and risking your pool leaning and even collapsing.
Can I put an above ground pool on pavers?
Pavers must sit on solid earth, level and covered up with a solid layer of 3-4 inches of compacted stone dust inside the pool. This will make for a solid base and a professional pool bottom that will last the lifetime of the pool. Pools are heavy when water is in them. Make sure the pavers are on solid earth!
How do I level my ground for a pool without sand?
There is an easy way to do this. Screw two 2-by-4 boards together alongside each other so they are one or two feet longer than the diameter of your pool. Next, lay the attached boards on the ground where the pool will be and put a level on top. Slowly lift and lower one side of the 2-by-4s until it shows level.
How do you level ground by hand?
How do you level an inflatable pool on concrete?
Inside. It's it's tough to install the liner wrinkle. Free if all the water goes to one side first so you know want to get the base as level as you can. But hopefully your concrete slab is level.
How do I level my pool without digging?
You're gonna get your heavy twine or light rope whatever it is and you're gonna tie that to the metal ring. So you can pull the board. Around. While you're looking at the level to watch.
Do you need to level ground for Intex pool?
Level ground is extremely important. If it’s off by even 1-2 inches, a soft-sided pool can roll toward one side. This puts unnecessary stress on the pool and can lead to a blow-out. Above everything else, this is the most important step in setting up an Intex pool!
