What kind of pump do I need to drain a pool?

Asked by: Glen Sprouse

Submersible Pumps If you’ve ever needed to drain your pool, it’s likely you’ve already encountered a submersible pump. A submersible pump, as the name implies, operates while fully submerged in water. These pumps feature a lot of horsepower, and primarily drain the water safely from swimming pools and spas.

How do you drain a pool with a pump?

https://youtu.be/Y8qMgAKTzcY
They always have a position that'll say drain or waste. Or if it doesn't have that you can just use the position backwash. So you're going to want to take the valve.

Can I use a sump pump to drain a pool?

And you see how high the plug is and it still leaves a good bit of water in here. So we've hooked up this sump pump. And this thing is pumping out water at a pretty good rate I'm pretty happy with it

Can I use filter pump to drain pool?

Using the Pool Filter Pump to drain the pool



Place the filter multiport valve in the Recirculate position and turn on the pump, after you roll-out the backwash hose; monitor pool draining closely. Eventually the pool drain will begin to suck air, with about 6-9″ of water left in the deep end, if you’re lucky.

Can I use my pool pump to drain my above ground pool?

All you need is a medium-size water or vacuum pump. Unroll the pump’s intake hose so that it reaches the center of the pool (or as close to it as possible), and submerge it in the pool. Place the outlet hose so the exiting water doesn’t flood the area, but drains off away from the pool. Dry your hands thoroughly.

What can I use to pump out water?

Utility pumps are used for short-term purposes or emergencies to transfer liquids from one place to another. If you’re just moving water, go with a utility pump. However, if the water contains debris or solids, go with a trash pump or sewage pump, instead.

How do I get water out of the bottom of my pool?

Since both draining methods will not drain pool water to the last bit, you need to remove the extra liquid left at the bottom.



To do so, you can:

1. Use a wet vacuum to suck the stagnant water.
2. Sweep the liquid into the drain.
3. Remove the pool liner and flip it over somewhere your property to get rid of extra water.

What size sump pump do I need to drain pool?

For most average-sized homes in areas with average water tables, a 1/3 HP sump pump should be sufficient. Typically, 1/3 HP pumps can handle 7′ – 10′ vertical lifts from the sump pit if they have one 90-degree elbow and a horizontal pipe run between 3 feet and 25 feet.

How do you empty a pool with a submersible pump?

So we've moved it more to the deep area now i just got to plug it in it should kick in all right so i had to move it. Again either fell over but now i got it like right at the deep.

How can I empty my pool without a pump?

How to Empty a Pool Without a Pump

1. Place one end of a water hose in the pool. …
2. Take the other end of the hose to where you want the water to drain. …
3. Siphon the water out of the pool by placing your mouth on the end of the hose and sucking repeatedly until water comes out.

Can I use a shop vac to drain my pool?

And what I did was I stuck the end of the vacuum hose to my shop vac sucked the water until it started flowing it's kind of like a vacuum. And then once I release that I pulled it off.

Can I drain pool water on lawn?

Pool water is perfectly safe for grass in small levels. If you want to drain your pool onto your lawn, make sure to properly dilute the chlorine level. Be careful not to flood your lawn while draining, because that can kill the grass.