How long does it take to replace a telephone pole?

Asked by: Marianna Philley

How long does it take to replace a pole? Estimates vary greatly depending on the location and complexity of the replacement. General estimates range from 8 to 18 worker hours for a low-difficulty replacement and 20 to 75 worker hours for a high-difficulty replacement.

How long does it take to replace a pole?

The average pole replacement could take up to 3-4 hours under favorable conditions with no mitigating circumstances – or longer if unforeseen circumstances slow the crew down.

What happens if a telephone pole breaks?

Duke Energy tells WBTV after a pole breaks, they send out a crew to repair their own wires, sticking them onto a new pole. But legally, they can’t mess with other companies’ utilities. So, they keep those on the old one – and strap that old pole onto the side of their sturdy new one.

What is the life expectancy of a telephone pole?

Most power poles are much older than their useful life expectancy, which is likely somewhere around 50 to 60 years. But some of them are much older. Metal and concrete poles can last much longer than wood, but eventually all utility poles need to be replaced.

How long does a wooden telephone pole last?

An Electric Power Research Institute study suggested that wood poles lasted 50 years. Most utilities assume that their poles provide 30 to 40 years of service life.

How do they install telephone pole?

So any hardware that they use on a telephone pole they typically put a bolt all the way through the pole. So you can see the pole the boat will go all the way through there'll be a nut.

How fast does a car have to be going to break a telephone pole?

The other part was across the way. That was down over the bank.” Authorities haven’t said yet if speed was a factor in the crash. But Eastman told us that car must have been going well over the posted speed limit of 35 miles an hour.

Can you get electrocuted touching a telephone pole?

This is a common misconception that many people have about power lines. Power lines are not insulated and you should always avoid contact with them. It is quite possible for people to get electrocuted if you touch power lines.

Who is responsible for low hanging telephone lines?

Since the electric utility company is responsible for low hanging power lines, call the company that provides electricity to the area where the sagging lines are located and report the condition to them.

How often do utility poles get replaced?

30 to 40 years

Moisture from driving rain, whipping winds, and flash floods are capable of doing a number on material left to the elements. It’s quite a feat that the average lifespan of a utility pole is 30 to 40 years.

How much does it cost for a telephone pole?

With an average installed cost per pole of $3000, the total installed cost is $63 million per 1000 miles. Typically around 12% of these poles are inspected every ten years at an inspection cost of approximately $100 per pole using third-party inspectors.

How much does a 30 foot power pole weigh?

The density of pine is ~30 lbs per cubic foot, so this hypothetical pole weighs 30 * 24 = 720 pounds.

How much does a 45 ft telephone pole weigh?

45’OVERALL LENGTH | 38’6″ABOVE GRADE

How much weight can a telephone pole hold?

First a little about wood poles:



A #1 pole will support the most weight, a #10 the least. The test for a #5 pole is that it must support 1900 lbs. applied two feet from the top and pulled at a horizontal angle. If it does it passes the test–but when installed in the field it is only permitted to support 475 lbs.