How do you program a Proflame transmitter?
3 min read
Asked by: Emily Obey
How do I reset my Proflame transmitter?
Reset Using the Transmitter ON/OFF power button: Turn the system off by pressing the remote power button. After approximately 2 seconds press it again. Reset Using the Remote Flame Adjustment buttons: In the manual mode, use the down arrow to lower the flame all the way to OFF.
How do I sync Proflame transmitter?
Using a small object like a pen or paper clip hold the button in and listen for the audible beat. After the audible beep you can press any button on the remote sender.
How do I sync my Proflame 2 remote?
Pull the module out from behind the fireplace. Opening. Make sure that you have power to the fireplace. Set the on/off rocker switch to the off. Position.
How do I sync my fireplace remote?
The remote you take a pen. There's a button with learn written over it you just press it you're going to hear inaudible. Once you hear that take the remote point to that this go back and forth.
How do I unlock my Proflame remote?
The screen will immediately go into sleep mode and as you can see none of the buttons will work to unlock simultaneously press the load and the up arrow until the lock icon disappears.
How do I reset my fireplace remote?
So if your fireplace doesn't turn on another step to take would be to reset the codes in the memory within the receiver box to do so press and hold the learn button for 15 seconds.
How do I program my montigo fireplace remote?
Press and hold the reset button on the receiver shown. Here until you hear three beeps. Then turn the remote off then on again after this the receiver should produce.
How do I reset my Regency fireplace remote?
If you are unable to pair successfully the first time you may have to manually pair the remote and receiver to do this press and hold the black reset button on the front of the receiver.
What is AUX on fireplace remote?
Remote Actuated 120V Auxiliary Outlet
The auxiliary function controls the AUX power outlet on the Fan Control Module. To activate this function use the Mode Key (fig. 1) to index to the AUX icon (fig. 16 & 17). Pressing the Up Arrow Key will activate the outlet.
What is IPI CPI mode?
IPI (Intermittent Pilot Ignition) is when the pilot light is only lit when the control board gets the call for heat, either from a thermostat or from someone flipping a switch. CPI (Continuous Pilot Ignition) is when the pilot is lit constantly.
How do you use a fireplace remote?
Position. So if you go up here and you hold the up arrow. And then press the mode button at the same. Time. Let's try it here so there's a little lock key that locks the unit.
Why won’t my remote work on my gas fireplace?
If your receiver box is battery operated, make sure the batteries are new and have a full charge – do so for the remote control too. It’s possible that if you haven’t replaced the batteries recently corrosion may have formed and this could prevent the system from operating, and you’ll need to replace them.
How do you set a gas fireplace remote?
Ready to go we hit the on button and that beeps it'll turn the valve on turn the flame on just give it a second sometimes it takes a minute for the gas to flow.
