How do you pack a fishing rod on a car?

Asked by: Jason Fekete

How do you transport a fishing rod?

Make sure your rods are secured down with a bungee cord or something like that but if you're traveling with your rods in your vehicle.

How do you put a fishing rod on top of your car?

These just open up and close down these rubber pads secure the rods right on top of your roof. So if you're want to quickly conveniently just put the rods up there on your roof.

How do you pack a fishing rod down?

Just above where we plan to break the rod don't hook it into the tip don't hang it off of the tip I've seen this mistake a lot you hang it off the tip it catches on things while you're walking.

How do you carry a fishing pole on an SUV?

And watch this is as I put my car back. Together. Now I'm gonna be able to take my rods. And slide them nice and gentle with the eyelets.

How do you transport a two piece fishing pole?

Here's how it works as a little cap stick it on one end of your rod. As a groove in the end of it. The line goes around that groove. And a pull a little bit of extra line.

How do you pack fishing gear?

I break them down i put them into individual bags. And then i put into a bigger bag. And this does not go in checked in luggage. They like to the tsa likes to throw my bags around.

How do you tie a rod to a roof rack?

If you have more than one rod, bundle them together tightly below the reel with a small bungee. Face the handle end forward and place it on the side of the rack. Then use two bungees to secure the rod bundle to the roof rack, one for the front and one for the rear. Make sure they’re tight, without bending the rods.

How do you transport a long fishing rod?

So as you see here I have my rods in the bed of the truck. And this back here just made out a PVC pipe it's just something to rest the butts of the rod on. Just.

How do you make a roof rack for a fishing rod holder?

Using my this drill bit here i drew two holes in the bottom of the plastic plano storage container. And all i did was basically sandwich the bottom between the male and female abs couplers.

How do I make a roof rack without welding?

You drill holes use metal type in screw. You join them together. And then you just use a hammer and Hammer it flush with the conduit.

How do you make a fishing rod holder out of PVC pipe?

And cut our piece of PVC pipe. We're going to do these about 12 inches that we have that we can make 5 out of a 5 foot section of it make 10 basically so you take a little sharpie.