How do you make an infield drag?
3 min read
Asked by: Justin Powell
How To Build a Nail Drag
- Build with 2″x4″ boards.
- Pre-drill straight holes for nails.
- Use 40 penny nails.
- Use 1″x4″ to cover 2″x4″ on top to hold in nails.
- Use eye bolts and a chain for fulling. …
- Stagger nails 1″ apart and have 2 rows in each board.
How do you drag an infield?
Start by placing your mat drag approximately one foot inside the lip of your infield surface. The pattern should begin along the outside edge of the infield surface working your way inward. Alternate pattern in clockwise and counter clockwise direction. Dragging should be completed at a top speed of 3-4 mph.
How do you drag an infield skin?
Start by dragging around the center of the infield. Go in concentric circles. Making two or three passes overlapping the previous pass. With six to twelve inches of the drag as shown in the video.
Why do they drag the infield?
The purpose of these types of drags is to loosen the top ¼” to ½” layer of material at the surface of the infield. Remember, a metal baseball cleat is only 3/8” long so you really don’t want to penetrate much deeper.
How do you rake and drag a baseball infield?
Go side to side it's shorter it's quicker that's the worst thing that you can do for the field whether you're raking around home plate. We're more importantly raking the base line.
How do you make homemade drag?
These are you buck brackets that you use in electrical construction installing conduit and why not and they're like a u-bolt. We just stuck them through the holes on the brackets.
How do you drag an all infield dirt baseball?
Start by placing your mat drag approximately one foot inside the lip of your infield surface. The pattern should begin along the outside edge of the infield surface working your way inward. Alternate pattern in clockwise and counter clockwise direction. Dragging should be completed at a top speed of 3- 4 mph.
What does a nail drag do?
A nail drag is a very valuable tool for maintain your infield, but it must be used with great caution. The main reason for nail dragging is to cut down small undulations, permitting the looser material to be smoothed out by a subsequent pass with a screen drag. The drag should never penetrate more than ¼-½” deep.
When should you nail drag baseball field?
Following a rain event – It’s highly beneficial to get a nail drag onto your infield skin as soon as you can. Remember that regardless of the exact ratio of sand, silt and clay in your infield mix, heavy rain will cause most of the finer sized particles to sink and the coarser sand to rise to the top.
How do you edge an infield?
Another important step in proper maintenance of the infield is edging.
How To Edge the Infield Turf
- Run a string FROM TO BACK OF THE 1ST AND 3RD BASE BAG THROUGH THE MIDDLE OF SECOND BASE.
- Measure 36 inches from string toward the infield grass. …
- Cut along edge.
- Repeat same steps on the remaining base lines.
- See diagram.
Can you drag a wet baseball field?
It may seem contrary as rain is on it’s way, but keep moisture in your infield so that it maintains a firm stable surface. Drag your infield with a rigid steel drag mat to help seal off the surface. Again, always important to make sure there is some moisture in the infield surface otherwise it will not seal off.
How do you get rid of infield lips?
Another option to remove lips is to use a garden hose and high-pressure nozzle and spray the soil out of the grass back onto the infield dirt. Spray at a 45-degree angle toward the infield. This can be a very effective way to remove more soil than hand raking lips.
