How do you clean a fishing reel after salt water?

Asked by: Ellen Giannattasio

In a few words, you must clean your reel after every trip of saltwater fishing. To do so, first wash the reel with soap and water to remove dirt, salt, and lubricants, then use a water spray to rinse the reel. After drying the reel, use an oil and protective coating to keep it in prime condition and prevent corrosion.

How do you clean a reel that fell in salt water?

Man just give her a good rinse and with that wd-40. You just get it all up in there. Get all that saltwater. Stuff just pushed right out of there.

How do you take care of a saltwater rod and reel?

After returning from the fishing trip, clipping lines and removing reels, wash saltwater rods with warm water and gentle soap. Rinse and thoroughly dry and never store your rods before cleaning as corrosion of parts could occur.

How do you clean a baitcaster reel after saltwater?

Put some rubbing alcohol on your q-tip. And you're going to go down inside of the frame. And clean out the flange. Area the flange area inside the reel is where the flange of the spools ride.

Can you use salt away on reels?

I use it all the time, when we get home we use the diluted salt away in the bucket with a soft brush. Then rinse off the reels with water, then usually spray with WD 40 around the spools. Wipe them off and put away. Haven’t had any problems, been doing it for years.

What is the best way to clean a fishing reel?

In on your fishing rail on your line or wherever. You actually want to do is wash it with lukewarm or cold water. And not really close up say if you're spraying it with the hose.

Can I use my freshwater fishing rod and reel in saltwater?

Light tackle saltwater rods can be used in freshwater, but you would not want to use a freshwater rod in a saltwater environment because freshwater rods and fishing gear may not be made with the corrosion-resistant guides or components that saltwater rods are.

Should I rinse my reel after saltwater fishing?

In a few words, you must clean your reel after every trip of saltwater fishing. To do so, first wash the reel with soap and water to remove dirt, salt, and lubricants, then use a water spray to rinse the reel. After drying the reel, use an oil and protective coating to keep it in prime condition and prevent corrosion.

What to spray on fishing reels?

I know a lot of the real junkies out there going to freak but literally I'm just I'm trying to be comical about this that you can literally put this on your rod and reel it'll be fine.

How do you deep clean a spinning reel?

I spin the the bail. And that exposes another gear which is right here. And there's also a small bearing right here. But we'll just simply do with that is come in here clean any type of debris.

Is salt away just vinegar?

Salt away is just white vinegar (acetic acid) with a touch of detergent. Rather than buy the expensive stuff, make your own. I run a solution of it through my engine each salt water trip and also use it to wash salt off my fishing gear, the boat, etc.

Is salt away necessary?

Rinsing off equipment with fresh water before or after the Salt-Away treatment is not necessary. Leaving Salt-Away on the equipment after the application will allow the solution to drizzle and drain into areas that stay wetter longer and where pooled salt is more likely to cause corrosion from the inside-out.

Does salt remove rust?

Salt-Away has been helping boaters remove accumulated salt from salt clogged engines for years. If your engine has currently accumulated salt and rust corrosion, Salt-Away can break apart the salt and rust corrosion to a satisfactory condition, depending on the severity of the accumulation.

Does Dawn dish soap remove rust?

Here’s what I found out about cleaning rust: Dawn dish soap and white vinegar: You can either pour the Dawn on the stain (it has to be Dawn), then the vinegar on top and mix them into a paste, or mix the two together in a spray bottle (if your stains are on a vertical surface).