How do you change a starter belt on a EZ Go golf cart?
3 min read
Asked by: Stanley Roberson
How do you change a starter belt?
I use my left hand back where the driven clutches I recommend putting the glove on because you can't pinch your fingers in it it can take some skin off her touch pretty bad alright.
How tight should golf cart starter belt be?
How Tight Should a Golf Cart Drive Belt Be? The drive belt should not be too tight. If it’s too tight it can risk wearing off faster and it’s also harder to shift gears.
How do you check golf cart belts?
Down below and you don't want to press the moderate pressure on that belt you're gonna want to see about 3/16 to 1/4 inch of deflection. There no more than that that'll be your proper.
How much slack should be in a golf cart belt?
The reason for a Club Car drive belt being too tight can be because the drive belt is too small for the golf cart. The way to check if the belt is fitted correctly is to push the belt down with one finger at the center between the clutches. It should not deflect more than 1.5inches. It should not be less as well.
How do you tighten the belt on a Club Car golf cart?
Slide the old drive belt off the front drive clutch pulley, and then the rear clutch pulley. Slip the new belt around the golf cart’s clutch pulley, and then stretch it out over the front pulley. Pull the front pulley forward slightly to increase the belt tension, and then tighten the tension bolt with the wrench.
How does a golf cart starter generator work?
The starter generator works in two ways; the starter portion cranks the engine and the generator portion recharges the battery. When the gas pedal is depressed the starter cranks the engine over. When it begins to run on its own, the generator portion of the unit begins to charge the 12-volt battery.
How do I know if my EZGO clutch is bad?
What Kinds of Problems Can a Golf Cart Clutch Have?
- A sudden inability to maintain even slow speeds when heading uphill or changing elevation.
- Slowing down to a crawl, then speeding up, then slowing again, seemingly without reason.
- Jolting during startup.
- A ‘cranking’ sound when starting up the golf cart.
Why is my golf cart clutch not engaging?
The battery might be the key reason for the clutch not engaging. If the battery is faulty, the clutch systems will fail to generate enough power and will not function. If this is the case, it is advisable to replace or fix the battery and the issue should be resolved.
How do I stop my golf cart belt from squeaking?
Your belt may also be wearing down and even fraying which is a problem that can cause the belt to both squeak and whine as it runs. Replace any frayed belts right away, before they break, to avoid damaging your engine, and lubricate or replace any pulleys which continue to squeak on your cart.
How do I know if my pulley is squeaking or belt?
All you have to do is look at each pulley. And you just want to see if the belt is riding straight on the pulley. Or if it's moving side-to-side. You could also watch the pulley.
What causes a belt to squeal?
The belt squeals because there is improper tension in the belt drive system. This is usually caused by a worn automatic tensioner, but other causes can include a contaminated belt (oil, belt dressing, etc.) or a belt that is too long or worn out.
