How do you adjust a Hunter PGJ sprinkler head? - Project Sports
Nederlands | English | Deutsch | Türkçe | Tiếng Việt

Project Sports

Questions and answers about sports

How do you adjust a Hunter PGJ sprinkler head?

3 min read

Asked by: Rebecca Zahid

How do you adjust a Hunter PGJ?

To Increase Arc

  1. Insert the plastic key end of the Hunter wrench into the adjustment socket on top of the sprinkler.
  2. While holding the nozzle turret at the right stop, turn the wrench clockwise.
  3. Wrench will stop turning when adjusted to the maximum arc (360°). Do not go past this stop.
  4. Adjust to any arc between 40°-360°.


How do I adjust my Hunter sprinkler heads?


Direction if you need to increase the arc turn the tool clockwise as indicated by the plus sign next to the hole. Turning. The tool counterclockwise. Towards the minus sign will decrease the arc.

How do you adjust a Hunter fixed spray nozzle?

So grab and twist to adjust the right hand side twist just the nozzle just the tip of the nozzle to adjust the left hand side. And either tighten down to restrict and shorten the water flow.

How do you adjust a Hunter i20 sprinkler head?

If you need to adjust just in case you need to adjust the distance used to the top of the key which is a little allen. Take it into triangle until it locks. And if you turn it clockwise.

How do I turn off my Hunter I 20 sprinkler head?

You'll kind of feel it lock in the police. You can turn it clockwise. That actually turns the head right off for you you also have the pressure.

How do I extend the coverage on my sprinkler heads?

At the top of the nozzle, you will find a small screw. Use a flat-headed screwdriver to turn the screw to reduce or extend the radius of the nozzle opening. Set the arc position by adjusting the stem to cover the spray distance you need.

How do I turn on my Hunter sprinkler?

So if you put your selector over the manual single station it shows a station number with the run time you can use the right arrow to select what station it is that you want to turn on individually.

How do I reset my hunter sprinkler system?

Press and hold the Programs button, and at the same time press in the recessed Reset button with the tip of a ballpoint pen. Release the Reset button and continue holding the Programs button until the Reset Memory screen appears (then release the Programs button).

How do you reset Hunter X2?

X2 – Total Reset

  1. Turn the dial to the RUN position. …
  2. Press and hold the program button.
  3. Press and release the RESET button located inside the lower wiring compartment. …
  4. When the display reads the controller station count; (e.g. 14) then DONE, release the PRG button.

How do I manually start my hunter sprinkler system?

System i moved into my home there's a hunter control pad for a sprinkler. System and they didn't leave me a plan of where all the pipes were and i need to figure out which zones are where. And for how

Why is my Hunter irrigation system not working?

The most common reason your sprinklers are not watering is because the rain sensor is active. Do you have a rain sensor on your sprinkler system? If so, slide your sensor bypass switch into the “BYPASS” position (on an SRC, turn the dial into the RUN (Bypass Sensor position).

How do you test a hunter sprinkler system?

To initiate the test program:

  1. Press and hold the PRG button. The station number will be flashing.
  2. Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes. …
  3. After a 2 second pause, the test program will begin.