How do I turn off the governor on my club car?

Asked by: Bob Barefield

Look behind the governor to find a small metal rod that’s permanently attached to the club car and stretch your rubber band enough to connect it to that metal rod. Screw the plastic plate back in place. Once the plate is back in place, the governor is disabled.Jul 10, 2008

How do you turn the governor down on a golf cart?

If you find this rod, then your governor can be easily adjusted by accessing the cart’s inner workings. Simply adjust the cable coming from this metal protrusion, turning the nut counterclockwise to make the cable longer, effectively adjusting the cart’s governance to increase the overall speed.

How do you turn off the governor on a electric golf cart?

Well a golf cart's governor located is actually down in the motor. Compartment.

How do you make a Club Car golf cart go faster?

Your cart will thank you in the long-run.

Upgrade Your Golf Cart Motor.
Improve Golf Cart’s High-Speed Controller / Solenoid Contactor Relay.
Add Better Golf Cart Tires.
Use a Higher Powered Golf Cart Battery.
Keep Your Cart Light / Keep It Clean.

May 18, 2021

How do you adjust the governor on a electric club car?

Basically, an electric speed governor can be controlled by a tiny metal rod that’s located by the clutch of your golf cart. First things first: The electric speed governor is connected to a cable. You can adjust your speed by rotating the nut in a counterclockwise rotation.

How do I turn off speed governor?

Select on that and then. When you press cancel it means you're done and the tune will start to upload you'll hear the fan kick on and then when you're all done it'll say the press select to enter.

Where is the governor on a club car?

Well a golf cart's governor located is actually down in the motor. Compartment. Some of them these electric ones nowadays. Actually the governor isn't a true governor. It is a control speed.

How do I change the speed on my club car?

And the right position is your speed mode.

How can I make my electric golf cart go faster without upgrading?

How to Make an Electric Golf Cart Faster Without Upgrades

Wash Your Cart Properly. …
Inspect the Batteries. …
Refill the Battery Water. …
Check the Gas Pedal and Linkage. …
Measure the Tire Pressure. …
Charge Up Your Battery Unit. …
Lighten Up Your Cart’s Weight.

What does removing the governor do?

Removing the governor will increase the maximum rpm of the engine, but the internal parts of the Predator 212 are designed for 3600 rpm. Generally, this isn’t an issue with just the governor removal, the internal parts can usually withstand 5000 rpm without breaking apart (unless you go full throttle for too long).

Will an engine run without a governor?

Without a governor, you would need to adjust the throttle manually each time your lawn mower ran across a dense patch of grass or the engine will stall. A governor does the job for you by detecting changes in the load and adjusting the throttle to compensate.

Should I remove go-kart governor?

By removing the factory governor, the engine will be able to exceed the 3500rpm limit it was originally designed for. A cast iron flywheel can fail at any time, resulting in a catastrophic failure of the engine. It is recommended that you only remove the governor if you are fully aware of the risks.