How do I set up my Intex 12×30 pool?
4 min read
Asked by: Matt Bolden
How do I set up my Intex Easy Set pool?
Unroll the pool liner on top of the ground cloth. Making sure it is right side up. Do not drag the pool across the ground since that may result in leaks locate the filter connecting holes.
How do you prepare the ground for an Intex inflatable pool?
Use a line level to measure at 12-36 points around the pool. Then use flat shovels or a sod cutter machine to remove turf and lower the high spots. Add a one inch layer of sand. The Wrong Way: Eyeball the approximate area of the pool, and raise visible low spots by adding sand without actually checking for true level.
How long does it take to fill a 12ft Intex pool?
2-5 hours, depending on which pool, hose size and water pressure.
How do I hook up my Intex pool pump?
So you just have to screw them on. So you screw up in let's just hold up to that hole after you tighten it match. The two holes up and starts going in here Nicole should be seen from right there.
Do I have to put sand under my pool?
Sand is the recommended base material upon which an aboveground pool should sit. Sand is used under an aboveground pool to protect the pool’s vinyl liner from rocks and objects that could tear the liner. Also, sand under an aboveground pool acts as cushioning for its floor, making it more comfortable for feet.
Should I put a tarp under my Intex pool?
At the bare minimum, yes you should put a tarp underneath your Intex pool. Inflatable pools, Bestway and Summer Ways pools will also benefit from a tarp. What is this? Although a tarp will help protect your pool there are far better choices such as foam tiles or proper commercial under pool pads.
Should you put sand under Intex pool?
The folks at Intex are fairly clear that you should NOT put sand under your pool. The sand can easily wash away, causing voids under your pool and risking your pool leaning and even collapsing.
Can I install Intex pool on grass?
Installing an above-ground pool on a natural grass lawn is not a good idea, particularly if you plan on taking down the pool for part of the year. There are several reasons why natural grass and above-ground pools do not mix well, but one of the most important is that the pool is going to kill the grass.
How do I start my pool pump for the first time?
Steps to Prime Your Pool Pump
- Turn off the pump. …
- Switch to recirculate. …
- Release air. …
- Clean out the pump basket. …
- Fill the pump basket. …
- Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
- Check the water flow to your pump.
How do you set up a pool pump and filter?
With your hair and limb pot basket in front of the motor. And in front of that there'll be a spot to hook up this hose. Slide that on there as you can then you're gonna go ahead take your screwdriver.
How do I connect a hose to my Intex pool?
Make a tight mango. First water starts flowing from the tube. And hold it above the level of the pool it will stop again. And then this end of the hose will go to the lower connection.
How do I connect my Intex hose to PVC pipe?
And I'm gonna do that now you need to go from inch and a half to two inch threaded. Because that's what the white hose connects to now my local store didn't have you know one piece to consider though.
How do you set up a pool hose?
Before you begin, read the set-up instructions that came with your pool.
- Locate your pool’s skimmer, the intake basket mounted on your pool wall. …
- Place a hose clamp on one end of the hose. …
- Place a hose clamp on the opposite end of the hose. …
- Place a hose clamp over one end of the shortest hose.
