How do I know if I have a water pressure regulator? - Project Sports
Nederlands | English | Deutsch | Türkçe | Tiếng Việt

Project Sports

Questions and answers about sports

How do I know if I have a water pressure regulator?

4 min read

Asked by: Josh Evans

Your water pressure regulator is usually located right after the main shut-off valve for your water supply. This is typically found outside the house. Once you know where the shut-off valve is, you’ll find the water pressure regulator.

How do I know if my house has a water pressure regulator?

Where is it located? A water pressure regulator, if you have one, is usually located where the main water line comes into the house and after the main shut off valve. This way if you need to work on or change the water pressure regulator you can simply shut off the water main to do so.

What does water pressure regulator look like?

A water pressure regulator is a dome-shaped brass fitting that generally is found just past the main shutoff valve, where the main water line enters the house. It usually has an adjustment screw on top.

Where is a water pressure regulator installed?

Usually, water pressure regulators are installed where your main water line comes into your house, after the main shutoff valve. Measure your current pressure to get a baseline. Get a pressure gauge (available at most hardware and home improvement stores) and screw it onto one of your outdoor spigots.

What does pressure reducing valve look like?

A pressure reducing valve usually resembles a bell or dome. As mentioned earlier, you’ll usually see it alongside a gauge. It may be built right into your water meter. In most cases, however, you’ll find the valve in the form of a separate device that lies after the meter within your home’s water supply chain.

What is normal water pressure for a house?

between 40 and 60 PSI

Normal water pressure is generally between 40 and 60 PSI. Most homeowners prefer something right in the middle around 50 PSI. Once you measure the water pressure in your house, you can adjust it to a setting that is ideal for all family members and household uses.

How do I adjust the water pressure in my house?

The screw acts as a water pressure regulator. If you tighten the screw the water pressure will be more and if you loosen the screw the water pressure will be less. Turn the screw clockwise to tighten it and increase the pressure, or turn it counterclockwise to decrease the pressure.

Where is the water pressure valve located in a house?


It's most likely that the water main is located in the front of the house. This entry point is about four feet down from ground level if you can't find the entry point on the front wall.

Where is the pressure reducing valve in my house?

Pressure Reducing Valves. The Pressure Reducing Valve is designed to regulate the high water pressure supplied by the city to a level that is safe for homes. It is installed on the main water line. This is most commonly in the front flower bed, but it could also be behind an access panel in an inside wall.

Do faucets have regulators?

Flow restrictors on a kitchen faucet are small disk-shaped barriers that reduce the amount of water that comes out the faucet. They are installed in various configurations, and may be either added as a unit that replaces the conventional flow-directing screen on a faucet, or built in as part of the faucet itself.

Do water meters have pressure regulators?

A: On new installations, the pressure regulator is usually installed downstream, (on the house side) of the water meter, near the house.

What is the difference between a pressure-reducing valve and a pressure regulator?

Pressure relief valves are a type of safety valve that are commonly used to protect a system and the people operating it. Whereas pressure regulators take incoming line pressure and regulates it down to the pressure that is required by the downstream system.

How do I adjust the water pressure on my water meter?

Pressure-Reducing Valve

  1. Look on the main supply pipe near your water meter for a conical valve that has a bolt sticking out of the cone.
  2. To raise pressure, turn the bolt clockwise after loosening its locknut. Keep an eye on the gauge to make sure the pressure is within bounds, then retighten the locknut.