How do I add chemicals to my pool for the first time?
3 min read
Asked by: Scott Marshall
Tips for Adding Start-Up Pool Chemicals Add one chemical at a time, using a pool brush to distribute. Run filter pump while adding chemicals to circulate. Re-test the pool water after 8 hours of filter run time. Add chlorine shock when the sun is not directly overhead.
What order do you add pool chemicals to a new pool?
First when you first fill up your pool or you're first beginning your water balance. You need to adjust your total alkalinity following that you need to adjust your pH.
What to do when you first fill your pool?
What Do You Do After an Above Ground Pool Is Filled With Water?
- Step 1: Learn about how to prevent drowning and pool chemical injuries. …
- Step 2: Turn on the filter. …
- Step 3: Vacuum and skim off debris. …
- Step 4: Test the water, and then test it again. …
- Step 5: Enjoy your pool, but safely!
Should you shock a pool when you first fill it?
So you shock the pool allow the filter to run for about ten hours one full turnover of the water that has to be sure that all the water is treated and then make another do another test.
Do you need to shock a new pool?
In general, you should shock your pool when: Algae begins to grow in your pool. The free chlorine level of your pool measures zero. The chloramines or combined chlorine level rises above 0.5 parts per million (ppm).
How do you chlorinate a new pool?
To properly add kal hypo chlorine first determine how much you need to add based on the gallonage of your pool. Then dissolve the appropriate amount into a 5-gallon bucket of water.
Can you swim in a brand new pool?
Chlorine/non-chlorine chemicals – When adding chlorine or non-chlorine chemicals to “shock” your pool after a fill-up, wait about 24 hours or until levels are approximately 5 ppm. If you’ll only be adding liquid chlorine, it’s generally safe to swim after about 4 hours or until levels are 5 ppm or lower.
What chemicals do I need for a new above ground pool?
Once the pool is opened and the floor and walls have been brushed the first chemical you should add is chlorine to shock it. It’s recommended you add a gallon of liquid chlorine or pound of granular chlorine for every 5,000 gallons of water in the pool. You can also add more chlorine at the end of the opening process.
How many hours should you wait to swim after shocking a pool?
In general, it’s recommended that you wait up to 24 hours to hop into a pool after it’s been shocked, depending on the size of the pool, Alan says.
How soon after shocking pool can I swim?
And how long do you have to wait before you can swim? You should wait one hour per pound of shock product added, and then test the water to confirm the pH and chlorine are in the proper range before letting anyone enter the pool.
What happens if you go in a pool that was just shocked?
In terms of swimming in a pool that has been recently shocked, you may be exposing yourself to the risk of skin and eye irritation. If this happens then rinse thoroughly with clean water for several minutes (source).
Is pool shock the same as chlorine?
Shock is chlorine, in a high dose, meant to shock your pool and raise the chlorine level quickly. Chlorine tabs (placed in a chlorinator, floater, or skimmer basket) maintain a chlorine residual in the water. You do need to use both tabs and shock.
